Find Similar Products Like Diy Drip Irrigation at Amazon
|
Installing a water-efficient drip irrigation system is very easy. A typical system comprises of ½” plastic pipe that routes water from a hose spigot to trees, shrubs, and garden beds. The plastic tubing is fitted with little plastic nozzles, called emitters, at plant locations. Emitters are basically mini-sprinklers, and they come in a potpourri of forms depending on the type of plant you need to water. If you’re watering plant beds, assume you’ll need 1 ft. of tubing with emitters for each square foot of plant bed space. Your basic irrigation instrumentation come with only a few components, but may be augmented with pieces purchased “ala carte”. You’ll also need a punch for piercing the tubing and “goof plugs” for repairing errant punches. Tubing for drip irrigation is thin-wall flexible polyethylene or polyvinyl, specifically ¼” or ½” in diameter. Internal diameters may vary from manufacturer to manufacturer, so it’s good idea to buy pipe and fittings from a single source. Let’s begin to do it ourselves, 1. Connect the system’s supply tube to a water source, such as a hose spigot or a rainwater system. If you tap into your household water supply, use a pressure gauge to check water pressure. If pressure outperforms 50 pounds per square inch, install a pressure-reducing fitting before attaching the feeder tube. A filter will have to also be attached to the faucet before the feeder tube. 2. At garden bed location, start out installing drip emitters each 18″. You may also buy ½” PE tubing with emitters preinstalled. If you use this tubing, cut the feeder tube once it reaches the firstborn bed, and attach the emitter tubing with a barbed coupling. Route the tubing amid the plants so that emitters are over the roots. 3. For trees and shrubs, make a branch loop around the tree. Pierce the feed tube near the free and insert a T-fitting. Loop the branch around the tree and connect it to both outlets on the T-fitting. Use ¼” tubing for little trees, ½” for more spectacular specimens. Insert emitters in the loop each 18″. 4. Use micro sprayers for hard-to-reach plants. Sprayers may be connected directly to the main feeder line or positioned on short branch lines. Sprayers come in a assortment of spray patterns and flow rates; choose one most suitable for the plants to be watered. 5. Potted plants and raised beds may also be watered with sprayers. Place stake-mounted sprayers in the pots or beds. Connect a length of ¼” tubing to the feeder line with a coupler, and connect the ¼” line to the sprayer. 6. Once all branch lines and emitters are installed, flush the system by turning on the water and let it flow for a full minute. Then, close the ends of the feeder line and the branch line with figure-8 end crimps. Tubing may be left exposed or buried underneath mulch. Most helpful customer reviews 22 of 23 people found the following review helpful. The downside… The attachment from the spigot to the machine always leaked. I couldnt’ get it to fit perfectly right, despite trying everything in the manual. It would be really nice if they also included a rubber tube or something to fit over the threads and the end of the tube that attaches to the spigot to make sure nothing leaks. 16 of 16 people found the following review helpful. 15 of 15 people found the following review helpful. The system was somewhat easy to set up, although we did need to spend extra time re-adjusting the flow. Despite using almost all of the tubing, there are no leaks. The timer is wonderful! Just came home from a 2-week vacation & all of the deck plants are healthy. We have 15 pots on the system and needed to remove the flow control to push water to the end plants. Watering 20 plants might be optimistic. |
Not many options out there but this is decent
Happy with it …